| How to Send a Multi-page Fax from the Operation Panel - G7020 | Data Formats for Saving Scanned Images - G7020 | How to Reset the Remaining Ink Level Counter From a Windows PC - G7020 | How to Reset the Remaining Ink Level Counter - G7020 | How Do I Print with Black Ink Only? (Windows) - G7020 | Resetting the Wi-Fi Settings - CP1300 | Main Components of the Printer - TS8220 (Operation Panel) | Main Components of the Printer - TS8220 (Inside View) | Main Components of the Printer - TS8220 (Rear View) | Main Components of the Printer - TS8220 (Front View) | Printing on T-Shirt Transfer Paper | ECO Settings - G7020 | How Do I Reset the Settings on the Printer? - G7020 | Enabling / Disabling Quiet Mode - G7020 | Sending a Fax from a Mac - G7020 | - The High-Power Flash will not fire in the following situations:
-When shooting in M
- When the Flash Adjust is set to [Manual] - The flash charge time will lengthen as the battery charge gets weaker. Always set the power/mode switch to [OFF] when you finish using the flash.
- Be careful not to touch the flash window or sensor windows with your fingers while the flash is in use.
- In outdoor settings in the daylight, the flash may not detect illumination from the camera's built-in flash and may not fire.
- The flash may fire if another flash is being used in close proximity.
- The flash may not fire if there are no reflective items in its metering field.
- For continuous shooting, although the flash fires for the first shot, it does not fire for subsequent shots.
- If the battery usage time has considerably diminished, wipe the battery terminals well with a dry cloth as the terminals may be soiled with oil from one's skin or other dirt.
- If the battery is used in cold regions (0oC/32oF or lower), you are recommended to carry a spare lithium battery (CR123A or DL123). Keep the spare battery warm in your pocket until immediately before using it, and exchange it frequently with the battery in the flash.
- Remove the battery from the flash and store it in a dry and cool location if you will not use it for extended periods. Leaving it in the flash could lead to the battery leaking and damaging the flash.
- Fasten the attachment screws securely so that they do not loosen. Failure to do so may lead to the dropping of the camera and flash resulting in damage to .
|
 - Before affixing the bracket to the flash, check that the lithium battery (CR123A or DL123) is installed.
- To illuminate the subjects properly, install the flash so that it is up against the side of the camera and parallel with the camera's front panel.
- A tripod can be used even when the flash is attached.
|
Canon User Manuals Pdf Canon Hf G20 Manual
|
Comments are closed.